The Armory
Every system we install
Shingle tear-off and install is the bulk of our work. The rest of this list exists because the awkward sections — the flat porch, the steep valley, the storm tarp that has to go up today — are the ones that hold up your close-out.
Composition shingle
$110 / square
Our bread and butter. Full tear-off of one shingle layer and the ordinary underlayment, deck renailing, dry-in, flashing replacement, and install — starter, shingles, ridge cap, drip edge, and ordinary accessories. Loading and haul-off are included; dump is $10 a square unless you supply the dumpster. Every major manufacturer — GAF, Owens Corning, Malarkey, Atlas. Ridge vent, solar attic fans, and turtle vents installed as specified.
TPO single-ply
Quoted per job
TPO membrane for flat and low-slope sections — the back porch, the addition, the section over the garage that nobody else wants to touch. Hot-air welded seams, proper termination bar and counterflashing at every wall. Assembly, attachment, insulation, and removal scope are confirmed before we quote the job.
Torch-down modified bitumen
Quoted per job
Torch-applied modified bitumen for flat roof sections. Base sheet, cap sheet, proper lap and seam work, and full flashing at every curb, wall, and drain. Fire-watch protocol on every torch job. The exact system and removal scope are confirmed before we quote the job.
Decking replacement
$45 / sheet
Soft, rotten, or delaminated decking replaced by the sheet. Every sheet is photographed in place before it comes out, so the count on your invoice is a count you can hand to an adjuster.
Emergency tarping
$350 minimum
Storm damage tarping — secured properly, not thrown over a ridge and weighted with a brick. Keeps the interior dry while the claim is adjusted and the build gets scheduled. $350 covers up to five squares (500 square feet); each square over five is $35. You supply the tarp material.
Ventilation & penetrations
Ridge vent $5/LF to cut
Ridge vent only costs you something when we have to cut the deck for it — $5 per linear foot on a new run. If the roof already has ridge vent, there is no cutting to do and no charge: it comes off and goes back on as part of the build. Solar attic fans are installed as specified and quoted per job. Pipe boots, turtle vents, and flashings carry no charge at all — they are part of building the roof properly, not a line item. Every penetration is sealed and individually photographed, because that is where the leak callback comes from six months out.
Every system on this page
Carries the same lifetime workmanship warranty.
Shingle, TPO, torch-down, decking, flashing, and ventilation. Not just the easy ones — the flat porch and the steep valley are covered the same way the main field is.
What we don’t do
We do not sell to homeowners, we do not knock doors in your territory, and we do not take a job from a company we have subbed for. We are labor. Your customer stays your customer, and we never appear on a contract with them.
Send us your next roof.
Two minutes to fill out. Same-day confirmation. Composition shingle at $110 a square on the published rate card. Flat roofs are quoted per job and carry the same warranty.